2Pac Setup Windows

Setup, Software, Configuration for Windows 7 or higher

Installation and Accessories

This USB Stick Miner requires a actively powered USB Hub which can independently provide Two A for each USB port Wij have achieved good results with several USB Two.0 Hubs from Muuranker or Orico while Users reported several compatibility issues with USB Three.0 Hubs with Intel chipsets. For more details please check the following listig on bitcointalk.org.

Wij recommend a quality USB fan for operating clock rates greater than 150 MHz. Wij achieved best results with Arctic Breeze Mobile 92 mm (quiet, performant, high-quality).

Software

2Pac USB Stick Miners can calculate Hashes for SHA256D based Coins using a custom-built CGMiner branch which is available for download spil a pre-compiled version for Windows 7 or higher:

When plugged te, the Miner is registered te Windows Device Manager spil “2Pac BM1384 Bitcoin Miner”. For Windows 7 and Windows Ten operating systems wij recommend the use of Zadig USB driver & contraptions (http://zadig.akeo.ie/). Ter case of problems with the device detection, please attempt the Zadig WinUSB (libusb) driver:

Please note: After installation of Zadig USB driver devices, activate the List All Devices” option te “Options” spijskaart if the Miner does not vertoning up:

The following CMD instruction can be used to test if the Miner wasgoed correctly identified by the CGMiner Mining software:

Setup

The following guideline will embark up the CGMiner Software (example):

The Pool configuration which is used te the example above should be substituted by your own pool configuration gegevens. Please voeling your pool technicus or check the pool setup guide for more details. The example above shows a Solo-Mining configuration ter Con Kolivas’ Solo Mining pool.

The Clock Rate can be set with the following commandline parameter: gekko-2pac-freq. If you want to operate your Miner without active cooling, wij recommend a Clock Rate up to 100 MHz max.

The mining voorstelling depends on your Clock Rate and Core Voltage setup. You can calculate the average hash rate using the following formula:

  • Spectacle te GH = 0.11 * MHz
  • Example GH = 0.11 * 150 =&gt, Hashrate

16,Five GH/s (+-15%).

  • The higher the hashrate, the fatter is the deviation from this average, caused by ASIC manufacturing tolerances.
  • Leave a Reply

    Your email address will not be published. Required fields are marked *